Advertisement

14-bit bus switch/multiplexer for DDR2-DDR3 applications CBTW28DD14ET

CBTW28DD14ET

This 14-bit bus switch/multiplexer (MUX) is designed for 1.5 V or 1.8 V supply voltage operation, SSTL_15 or SSTL_18 signaling and CMOS select input levels. It is designed for operation in DDR2 or DDR3 memory bus systems, with speeds up to 1600 MT/s.

The CBTW28DD14 has a 1 : 2 switch or 2 : 1 multiplex topology and offers a 14-bit wide bus. Each 14-bit wide A-port can be switched to one of two ports B and C, for all bits simultaneously. The selection of the port is by a simple CMOS input (SELect). Another CMOS input (ENable) is available to allow all ports to be disconnected. Each port is non-directional due to the use of FET switches, allowing a multitude of applications requiring high-bandwidth switching or multiplexing.

The device is able to operate transparently in 1.5 V as well as 1.8 V applications. Typical usage is SSTL_15 signaling when using a supply voltage of 1.5 V, and SSTL_18 signaling when using a supply voltage of 1.8 V. The SEL and EN input signals are designed to operate transparently as CMOS input level signals in both 1.5 V and 1.8 V supply voltage conditions.

CBTW28DD14 uses NXP’s proprietary high-speed switch architecture providing high bandwidth, very little insertion loss at low frequency, and very low propagation delay, allowing use in many applications requiring switching or multiplexing of high-speed signals. It is available in a 4.5 mm × 4.5 mm TFBGA48 package with 0.5 mm ball pitch, for optimal size versus board layout density considerations. It is characterized for operation from -10 ℃ to +85 ℃.

Advertisement



Learn more about NXP Semiconductors

Leave a Reply